Saturday, 21 April 2012

#061 GAD BA3 - P1: Maya Design

The next part is to create the wall that the door will actually fit in to. After that I plan to create the hinge that holds the door in place and allows it to open.

Step 1: Create a large cylinder, 17.5 units by 17.5 units and 2 units deep.
Step 2: Clean the top and bottom surface.
Step 3: Create another cylinder, this time 17.9 units by 17.9 units and 1 unit deep.
Step 4: Again, clean up the edges on the top and bottom of the cylinder.
Step 5: Lower the second cylinder into the middle of the original one.
Step 6: Select the two faces and use Boolean Union.
Step 7: Create a cylinder, 0.8 units by 0.8 units by 5 units.
Step 8: Lower the cylinders into the middle of the other cylinder.
Step 9: Delete the upper and lower cylinder face.
Step 10: Duplicate the smaller cylinder and rotate it around the centre by 60 degrees 5 times.
Step 11: Select all the smaller cylinders and combine them.
Step 12: Use the Boolean Difference tool to cut them into the cylinder.
Step 13: Create a large plane, 20 units tall and 40 unit wide.
Step 14: Extrude the planes face by 2 units.
            
Step 15: Select the inner cylinder and the wall and use the Boolean Difference tool.
Step 16: Copy in the pieces from the last section and place them in the middle to match the hole.

No comments:

Post a Comment